JDM Toyota

Toyota Factory Part for JDM Model now we have some in stock.

More information for JDM Factory Parts, Please call: Maxwell at 626-961-6284/ 310-869-8083

Complete kit comes with all the bolts you need; 100% bolt-on, easy to install.

We have limited units in-stock. Please call for detail. Special order or group buy also available

AE86 Door Panel Cap, it is only color available in the whole world. JDM Fender Molding for AE86 Trueno in White color only.

Pinion Shim for AE86 rear end, we do have every single size. TRD Solid Racing Spacer for AE86, good for track and performance driving.

Looking for 4.5:1 final gear set for AE86 GTS, click here

Oil Filter Adaptor Kit for install a Oil Cooler is a must component. It fitted most Toyota Model included small engine 1NZ-FE.

The adaptor plate must be use ORB #10 fitting with O-Ring, it designed for high flow contour. It also come with a 1/8" NPT

Oil Temp Sensor Port.

1SZ-FE Shimless Lifter 4A-GE 16V Lifter with Shim Cut Section

We also carry some Brand New Shimless Lifter. Originally it using on TOYOTA 1SZ-FE engine, and it is same size with

4AG-16V. Before you decide to get a Shim under bucket kit for your High-Lift cam, you should think about this. Shimless

Lifter comes with different sizes. They are only $268.00 per kit for 16V and Shim under bucket cost you more than $500.00

plus you have to replace the spring retainer by remove the cylinder head. Shimless Lifter just need to remove the OE lifter

and shim and replace with a right size 1SZ lifter, it save lots of time. Before you order a set on Shimless Lifter, you have to

check the valve clearance and make sure that is correct; then you need to remove the camshaft from your 4AG engine and put

the lifter out, measure the total thickness on the lifter with the shim together and put down the sizes on the paper. If we don't

have the size for you right away, we should have them in a week from Japan. Email or call us when you are ready to order.